



This Titainium screw set for the IF18 will effectively reduce the weight of the lower section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 47pcs offering a weight saving of 12g over the standard steel screws.
This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.
New option part for INFINITY IF18. This new upper suspension shaft with 3mm stopper not only improves the strength and reliability during long finals it also speeds up your maintenance time.
The shaft itself is a heat-treated high-strength spec with a polished finish.
Wide roll bar adds further stability when holding the car and refuelling.
This Titainium screw set for the IF18 will effectively reduce the weight of the lower section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 47pcs offering a weight saving of 12g over the standard steel screws.