G124 - SHOCK PISTON (φ0.9x3 HOLES) 2pcs
G124 New 3 hole shock pistosn for IF15. Recommended for the front end on IF15 on med-high traction tracks to increase corner speed. Can also be used in the rear and IF18 shocks.
16 other products in the same category:
R0012-01 - PULLY SET A (for FRONT ONEWAY, MIDDLE SHAFT)
Conventional pulley set is divided into good value Front / Rear section.
R0269 - FRONT LOWER ARM (HARD)
Making the material harder than the standard kit version the flex of the arm is greatly reduced. Offering increased response at high speed and improved consistency in high grip and high temperature conditions.
R0075-60R - FRONT UNIVERSAL SWING SHAFT 90°（L 60）2pcs
By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.
R0262 - ALUMINUM SERVO HORN SET 23T (SANWA PGS-XR, KO RSx3)
A new aluminium servo horn designed specifically for IF18. 23T specification for servos made by Sanwa and KO. By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).
R0259 - ALUMINUM SERVO SAVER SET（UP SIDE）
Maintenance and adjustability is greatly improved with this servo saver arm by mounting to the steering rod upper side. Also, by changing and optimizing the arm length of the servo saver, the steering response will be higher than before.
G124 New 3 hole shock pistosn for IF15. Recommended for the front end on IF15 on med-high traction tracks to increase corner speed. Can also be used in the rear and IF18 shocks.