R0257 - FRONT UPPER SUS SHAFT SET STOPPER TYPE
New option part for INFINITY IF18. This new upper suspension shaft with 3mm stopper not only improves the strength and reliability during long finals it also speeds up your maintenance time.
The shaft itself is a heat-treated high-strength spec with a polished finish.
16 other products in the same category:
R0075-60R - FRONT UNIVERSAL SWING SHAFT 90°（L 60）2pcs
By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.
R0263 - ALUMINUM SERVO HORN SET 25T (SAVOX SC2271SG, Futaba BLS371SV, CB700)
A new aluminium servo horn designed specifically for IF18. 25T specification for servos made by Savox (SC2271SG) and Futaba (BLS371SV). By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).
R0242 - REAR LOWER ARM PLATE LC (CARBON GRAPHITE) 2pcs
3.0mm shorter/Good matching for standard INFINITY(CM-00001)
R0264 - IF18 TITANIUM SCREW SET（UPPER）
This Titainium screw set for the IF18 will effectively reduce the weight of the upper section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 111pcs offering a weight saving of 18g over the standard steel screws.
R0281 - SET SCREW M4x8mm ROUND TOP (4pcs)
Down stop adjustment screw for front and rear lower arms. The tip has a smooth round shape, making it difficult to damage the contact area with the main chassis.
New option part for INFINITY IF18. This new upper suspension shaft with 3mm stopper not only improves the strength and reliability during long finals it also speeds up your maintenance time.
The shaft itself is a heat-treated high-strength spec with a polished finish.