R8015 - FRONT SPRING φ2.0-6TL

Newly designed easy access front one way

This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.

R0262, R0263 Repair parts for accessories. Because it is an ultra-low head type with 1.5 mm hex hole and a thickness of 1.2 mm, it can be used in various tight spaces.

For rear only

A new aluminium servo horn designed specifically for IF18. 25T specification for servos made by Savox (SC2271SG) and Futaba (BLS371SV). By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).

Easy to check fuel

1.5mm shorter

Long body post to reduce body mount plate to inclease chassis flex.

This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.

Just a single item, 48T Rear pulley from pulley set.

This Titainium screw set for the IF18 will effectively reduce the weight of the upper section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 111pcs offering a weight saving of 18g over the standard steel screws.