R8012 - FRONT SPRING φ1.9-7T

To change ackerman angle (more increase angle of outside front tyre)

This Titainium screw set for the IF18 will effectively reduce the weight of the upper section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 111pcs offering a weight saving of 18g over the standard steel screws.

Option part for Infinity IF18. This brake disc offers a more stable braking performance during long runs. The disc is made from thicker material than the standard item and also vented to efficiently dissipate heat. Improved brake feeling, spring included.

Just a single item, 48T Rear pulley from pulley set.

 Use with R0188

spare parts of R0251

By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.

This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.

This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.

Super low friction rubber belt