

This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.
A new aluminium servo horn designed specifically for IF18. 23T specification for servos made by Sanwa and KO. By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).
This vivid red aluminium screw set for the IF18 will significantly reduce the weight of the upper section of the car while also adding a fresh cool look. Using these screws willoffer a mild driving characteristic by increasing chassis flexibility in a well balanced manner. The set contains a total of 111pcs offering a weight saving of 30g over the standard steel screws.
This black aluminium screw set for the IF18 will significantly reduce the weight of the upper section of the car while also adding a fresh cool look. Using these screws willoffer a mild driving characteristic by increasing chassis flexibility in a well-balanced manner. The set contains a total of 111pcs offering a weight saving of 30g over the standard steel screws.
Body stiffener for 1/8 body (Only large type for rear)
Uses harder material than standard IF18 kit. Increases the rigidity of the suspension and improves the corner speed.
This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)
Uses lightweight carbon material. Chassis rigidity can be increased while suppressing weight increase. Improves steering response.