R0221 - UPPER DECK STIFFENER (CARBON GRAPHITE)

Body stiffener for 1/8 body (Only large type for rear)

Possible to adjusting flex by cutting front rib

IF18 logo decal. Pre-cut decal is easy to attach. Size: 210mmx148mm

This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.

Body stiffener for 1/8 body (Only small type)

Making the material harder than the standard kit version the flex of the arm is greatly reduced. Offering increased response at high speed and improved consistency in high grip and high temperature conditions.

Easy to check fuel

This Titainium screw set for the IF18 will effectively reduce the weight of the lower section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 47pcs offering a weight saving of 12g over the standard steel screws.

Uses harder material than standard IF18 kit. Increases the rigidity of the suspension and improves the corner speed.

This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)

This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.