R0192 - FRONT LOWER ARM PLATE OUTSIDE (CARBON GRAPHITE) 2pcs

Conventional pulley set is divided into good value Front / Rear section. 

Super low friction rubber belt

 Use with R0188

By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.

Wide roll bar adds further stability when holding the car and refuelling.

3.0mm shorter/Good matching for standard INFINITY(CM-00001)

R0262, R0263 Repair parts for accessories. Because it is an ultra-low head type with 1.5 mm hex hole and a thickness of 1.2 mm, it can be used in various tight spaces.

This Titainium screw set for the IF18 will effectively reduce the weight of the lower section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 47pcs offering a weight saving of 12g over the standard steel screws.