R0217-09 - SERVO SAVER NOSE (09mm) CARBON GRAPHITE
To change ackerman angle (more increase angle of outside front tyre)
R0189 - FRONT WHEEL PLATE CARBON GRAPHITE (aerodisk) 2pcs
16 other products in the same category:
R0260 - ENGINE SCREW & WASHER SET
This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.
R0258 - REAR BODY MOUNT SHAFT SET STOPPER TYPE
New option part for INFINITY IF18. This new replacement body mount shaft with 3mm stopper not only improves the strength and reliability during long finals it also speeds up your maintenance time and allows for the body mount to move more freely. The shaft itself is a heat-treated high-strength spec with a polished finish.
R0257 - FRONT UPPER SUS SHAFT SET STOPPER TYPE
New option part for INFINITY IF18. This new upper suspension shaft with 3mm stopper not only improves the strength and reliability during long finals it also speeds up your maintenance time.
The shaft itself is a heat-treated high-strength spec with a polished finish.
R0284C - LIGHT WEIGHT LIP SPOILER SET (Carbon style with Logo)
This light weight lip spoiler set has a reduced weight of approx 5g including fastener and nut. Recommended for use with a lightweight bodyshell. Special carbon style features a printed INFINITY logo. A guide scale is included to help set the exact height of the spoiler.
R0217-10 - SERVO SAVER NOSE (10mm) CARBON GRAPHITE
To change ackerman angle (more increase angle of outside front tyre)
R0280 - BRASS BATTERY PLATE (IF18)
A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.
R0275-TN - BELT TENSIONER FLANGE (TITAN)
This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)
