Repair parts for R0394
New part that improves response when entering/exiting corners. This pin position is 0.5mm higher and 1mm wider than the standard R0230-IN suspension pin position.
This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.
New stabilizer stopper for IF18-3 front stabilizer.
By making the contact surface with the bearing spherical, smoother movement of the stabilizer is acheived.
Durability has also been greatly improved by using steel.
Available in 2.3, 2.5, and 2.7mm.
Compatible stabilizers
Stopper 2.3mm (R0382S23): 2.0mm, 2.1mm, 2.2mm, 2.3mm
Stopper 2.5mm (R0382S25): 2.4mm, 2.5mm
Stopper 2.7mm (R0382S27): 2.6mm, 2.7mm
Not only has rigidity been increased by using A7075, but the pivot height has been raised by 2mm compared to the standard part R300B/300H, providing more responsive steering and changing the camber change rate. To ensure clearance inside the wheel, the ball has been downsized from 8.5 to 8.0mm and the screw cap from 10 to 9mm and tilted by 10°. A specially prepared 8mm titanium ball is included to ensure proper steering angle. The main body is hard anodized.
A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.
A special manufacturing process ensures long life and consistent performance.
As the overall length is approximately 11mm,
please use it together with R0413 CLUTCH SPRING HOLDER (for R0412).
Making the material harder than the standard kit version the flex of the arm is reduced and rear traction is increased. Offering increased consistency in high grip and high temperature conditions.
Compared to the standard plastic rear body mount, this new carbon mount increases the height of the body by 3mm (Almost the limit within the regulation of IFMAR). In addition, the cross-sectional shape of the carbon plate and A7075 adapter matches the latest body shapes such as XTREAM's Diablo and Protoform's R19 without any gaps. This allows the downforce to be transferred to the tires without loss and improving rear grip. The left and right carbon plates can be fine-tuned with set screws to accommodate individual body shapes. The connection to the car body can be made in three step width directions, and also absorbs the twisting of the mounting part when toe-in is applied.
Repair parts for R0394
