

Front Shock Stay LD(Lay Down) that offers a position one step lower than the conventional R0081 (included in the kit). The center position of the R0336 is the same as the lower hole of the R0081. It's designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
Lightweight and rigid flat head screw made of titanium, with the optimum length for installation of 2-speed spur gears for more secure tightening.
Option part for IF18. This aluminum body mount spacer is to be used together with the optional 1 piece carbon mounting plate (R0198) Offers extra body post stability and is available in both silver and red.
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
New 0.8 module spur gear designed for high precision, high strength, and high durability. Gear specifications have been redesigned to provide uniform backlash for all tooth number combinations. The tooth width of the 2nd gear spur gear (R0409T56-T58) has been increased by approximately 12% to achieve even higher strength and durability. *Cannot be used in combination with conventional 0.8 module spur gears (R0247-60-62 and R0248-56-58) to prevent gear breakage. *Pinion gears for IF18-3 (R0384T18, R0384T19, R0385T23, R0385T24) must be used.
Connects the brake mount L/R to the rear lower bulk, This part increases the rigidity of the rear area. It improves the rear grip.