


This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)
The drivetrain of the IF18-3 has been lightened to improve response during acceleration and deceleration.
The weight is approximately 7g lighter than the 8mm shaft.
New 0.8 module spur gear designed for high precision, high strength, and high durability. Gear specifications have been redesigned to provide uniform backlash for all tooth number combinations. The tooth width of the 2nd gear spur gear (R0409T56-T58) has been increased by approximately 12% to achieve even higher strength and durability. *Cannot be used in combination with conventional 0.8 module spur gears (R0247-60-62 and R0248-56-58) to prevent gear breakage. *Pinion gears for IF18-3 (R0384T18, R0384T19, R0385T23, R0385T24) must be used.
Making the material harder than the standard kit version the flex of the arm is reduced and rear traction is increased. Offering increased consistency in high grip and high temperature conditions.
Not only has rigidity been increased by using A7075, but the pivot height has been raised by 2mm compared to the standard part R300B/300H, providing more responsive steering and changing the camber change rate. To ensure clearance inside the wheel, the ball has been downsized from 8.5 to 8.0mm and the screw cap from 10 to 9mm and tilted by 10°. A specially prepared 8mm titanium ball is included to ensure proper steering angle. The main body is hard anodized.
A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)
New 0.8 module spur gear designed for high precision, high strength, and high durability. Gear specifications have been redesigned to provide uniform backlash for all tooth number combinations. The tooth width of the 2nd gear spur gear (R0409T56-T58) has been increased by approximately 12% to achieve even higher strength and durability. *Cannot be used in combination with conventional 0.8 module spur gears (R0247-60-62 and R0248-56-58) to prevent gear breakage. *Pinion gears for IF18-3 (R0384T18, R0384T19, R0385T23, R0385T24) must be used.
IF18-3 setting parts