A006-10 - ALUMINUM WASHER 3x6x1.0mm (Black/10pcs)


16 other products in the same category:

R0337 - REAR CARBON BODY MOUNT SET

Compared to the standard plastic rear body mount, this new carbon mount increases the height of the body by 3mm (Almost the limit within the regulation of IFMAR). In addition, the cross-sectional shape of the carbon plate and A7075 adapter matches the latest body shapes such as XTREAM's Diablo and Protoform's R19 without any gaps. This allows the downforce to be transferred to the tires without loss and improving rear grip. The left and right carbon plates can be fine-tuned with set screws to accommodate individual body shapes. The connection to the car body can be made in three step width directions, and also absorbs the twisting of the mounting part when toe-in is applied.

R0328 - ALUMINIUM CENTERING BUSHING (IF18-2)

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

R0341 - CARBON REAR STIFFENER SET(IF18-2)

Installing this part significantly improves rigidity to the rear section of the chassis around the gear area, enabling more reliable power transmission, increasing acceleration and top speed. In addition to this the increased pitching rigidity of the chassis helps to add initial response and a sharper steering feel.