R8009B - REAR BELT (URETHANE) 201

DISCONTINUED

Long life rubber belt

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Maintenance and adjustability is greatly improved with this servo saver arm by mounting to the steering rod upper side.  Also, by changing and optimizing the arm length of the servo saver, the steering response will be higher than before.

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

DISCONTINUED

Making the material harder than the standard kit version the flex of the arm is reduced and rear traction is increased. Offering increased consistency in high grip and high temperature conditions.

High-precision machined aluminum spring guide for improved steering response and rear traction. Hard coating is applied to ensure durability of the contact area with the spring and to maintain good condition for a long period of time.

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)

This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.