R0262 - ALUMINUM SERVO HORN SET 23T (SANWA PGS-XR, KO RSx3)

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Front Shock Stay LD(Lay Down) that offers a position one step lower than the conventional R0081 (included in the kit). The center position of the R0336 is the same as the lower hole of the R0081. It's designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.

The material and coating have been updated to significantly improve crash resistance and durability compared to the standard items. The shaft is highly durable and resistant to scratches even after long periods of use.

To change ackerman angle (more increase angle of outside front tyre)

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

3.0mm shorter/Good matching for standard INFINITY(CM-00001)

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

1.5mm shorter