R0260 - ENGINE SCREW & WASHER SET

This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.

16 other products in the same category:

R0284RC - LIP SPOILER SET (Carbon style with Logo/Regular Weight)

Regular weight lip spoiler for 1/8 racing car body made of 0.8mm thick material. Includes a scale that is useful for precisely setting the lip spoiler height.
Compared to the light weight (R0284C), the lip spoiler itself is more rigid, enabling it to transfer downforce to the car body more effectively even at high speeds.

R0327 - ALUMINIUM OFFSET BUSHING (IF18-2)

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

R0284 - LIGHT WEIGHT LIP SPOILER SET

This light weight lip spoiler set has a reduced weight of approx 5g including fastener and nut. Recommended for use with a lightweight bodyshell. Special carbon style features a printed INFINITY logo.

R0343 - REAR SUSPENSION ARM SET (Long Upper Type/IF18-2)

By extending the upper arm ball end boss by 3.5mm, the upper arm can be lengthened without any difficulty. The hole in the upper arm itself, which is combined with the upper arm, is also deeper, so it can be used in its shortest setting. Its now possiible to use this part for wide range of settings.

R0276 - IF18 CLUTCH TOOL

Adjust the amount of spring tension on your clutch nut quickly and easily without disassembling the clutch bell. Featuring the Infinity logo the tool is also finished in black and red to match the brands striking colours.

R0331 - Fuel Tank Spacer Set(IF18-2)

A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.