

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.
Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.
This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.
This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.
Uses a softer material than the standard R0303-01.
Steering response is more mild and easy to drive.
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
As used by the team drivers at the 2019 World Championships. The chassis offers increased corner speed while also offering a smoother feel, this has been achieved by changing the shape of both the front and the rear of the chassis.
It is also possible to change the characteristics for different track conditions by adding a carbon plate (sold separately) to increase rigidity of the front section and adding an M3 screw to the rear.
A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.