CM-A005-10 - ALUMINUM WASHER 3x6x1.0mm (Red/10pcs)

White based INFINITY logo decal

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

As used by the team drivers at the 2019 World Championships. The chassis offers increased corner speed while also offering a smoother feel, this has been achieved by changing the shape of both the front and the rear of the chassis.
It is also possible to change the characteristics for different track conditions by adding a carbon plate (sold separately) to increase rigidity of the front section and adding an M3 screw to the rear. 

Newly designed easy access front one way

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.