Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
High-precision machined aluminum spring guide for improved steering response and rear traction. Hard coating is applied to ensure durability of the contact area with the spring and to maintain good condition for a long period of time.
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
Front Shock Stay LD(Lay Down) that offers a position one step lower than the conventional R0081 (included in the kit). The center position of the R0336 is the same as the lower hole of the R0081. It's designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
Maintenance and adjustability is greatly improved with this servo saver arm by mounting to the steering rod upper side. Also, by changing and optimizing the arm length of the servo saver, the steering response will be higher than before.
These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.
Installing this part significantly improves rigidity to the rear section of the chassis around the gear area, enabling more reliable power transmission, increasing acceleration and top speed. In addition to this the increased pitching rigidity of the chassis helps to add initial response and a sharper steering feel.
Regular weight lip spoiler for 1/8 racing car body made of 0.8mm thick material. Compared to the light weight (R0284), the lip spoiler itself is more rigid, enabling it to transfer downforce to the car body more effectively even at high speeds.
