R0248-57 - 0.8M 2nd SPUR GEAR 57T

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.

To change ackerman angle (more increase angle of outside front tyre)

Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.

Reverse movement from the standard type

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

Long life rubber belt

Uses a softer material than the standard R0303-01.
Steering response is more mild and easy to drive.

Uses harder material than standard IF18 kit. Increases the rigidity of the suspension and improves the corner speed.

Reverse movement from the standard type