

To change ackerman angle (more increase angle of outside front tyre)
The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
This light weight lip spoiler set has a reduced weight of approx 5g including fastener and nut. Recommended for use with a lightweight bodyshell. Special carbon style features a printed INFINITY logo. A guide scale is included to help set the exact height of the spoiler.
Front Shock Stay LD(Lay Down) that offers a position one step lower than the conventional R0081 (included in the kit). The center position of the R0336 is the same as the lower hole of the R0081. It's designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.