

Body stiffener for 1/8 body (Only small type)
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.
A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.
Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.
Making the material harder than the standard kit version the flex of the arm is reduced and rear traction is increased. Offering increased consistency in high grip and high temperature conditions.
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
The front roll center can be lowered by replacing the kit parts with this front knuckle base. With these adjustments your IF18-II has the potential for even higher turning/steering performance. Recommended for use with thick front stabilizer from 2.6 - 3.0mm.
This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.
Uses lightweight carbon material. Chassis rigidity can be increased while suppressing weight increase. Improves steering response.
Compared to the standard plastic rear body mount, this new carbon mount increases the height of the body by 3mm (Almost the limit within the regulation of IFMAR). In addition, the cross-sectional shape of the carbon plate and A7075 adapter matches the latest body shapes such as XTREAM's Diablo and Protoform's R19 without any gaps. This allows the downforce to be transferred to the tires without loss and improving rear grip. The left and right carbon plates can be fine-tuned with set screws to accommodate individual body shapes. The connection to the car body can be made in three step width directions, and also absorbs the twisting of the mounting part when toe-in is applied.
Body stiffener for 1/8 body (Only small type)