![](http://www.creationmodel.net/catalog/778-large_default/r0204-bearing-sp-5x8x25-2pcs.jpg)
![](http://www.creationmodel.net/catalog/778-home_default/r0204-bearing-sp-5x8x25-2pcs.jpg)
3.0mm shorter/Good matching for standard INFINITY(CM-00001)
A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)
The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.
This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.
This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.
Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.
DISCONTINUED