R0197 - REAR BODY MOUNT PLATE 0.5mm (CARBON GRAPHITE)

Maintenance and adjustability is greatly improved with this servo saver arm by mounting to the steering rod upper side.  Also, by changing and optimizing the arm length of the servo saver, the steering response will be higher than before.

Possible to adjusting flex by cutting front rib

Newly designed easy access front one way

The new SS version is more durable than previous gear housings due to a review of the manufacturing process, including the shape and materials used.
As the name "SS => Strong Support" suggests, the spur gear support is increased, minimizing the chance of stripping gears.

Easy to check fuel

A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)

Spare parts for R0323.

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

For rear only

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.