R0041 - STABILIZER STOPPER 2.0mm 2pcs

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Uses a softer material than the standard R0303-01. Increases crash resistance. The steering response is also mild.
(M2x8mm Flat Head Screw is not included.)

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Long life rubber belt

Change of contents of conventional R0067 (to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.

DISCONTINUED

This light weight lip spoiler set has a reduced weight of approx 5g including fastener and nut. Recommended for use with a lightweight bodyshell. Special carbon style features a printed INFINITY logo.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)

Changed to long upper arm

IF18 logo decal. Pre-cut decal is easy to attach. Size: 210mmx148mm

Newly designed easy access front one way

Long life rubber belt

DISCONTINUED