Changed contents of conventional R0117 (changed to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.
The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.
This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.
These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.
The material and coating have been updated to significantly improve crash resistance and durability compared to the standard items. The shaft is highly durable and resistant to scratches even after long periods of use.
Front Shock Stay LD(Lay Down)WIDE features a position 2mm wider each side than the R0336. Offers increased initial response than R0336. It is designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.
A carbon stiffener that can be added to the front lower arm to increase rigidity. Increased steering response and higher cornering speeds can be achieved in certain conditions. Its also possible to adjust the flex and rigidity by the number of mounting screws used.
Uses harder material than standard IF18 kit. Increases the rigidity of the suspension and improves the corner speed.
This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.
By installing this Front Carbon Wheel Plate on the front knuckle, turbulent air generated in the front wheels during driving is cleaned up offering more stable driving characteristics. The effect is especially noticeable on high-speed circuits.
A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.
Changed contents of conventional R0117 (changed to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.
