The new SS version is more durable than previous gear housings due to a review of the manufacturing process, including the shape and materials used.
As the name "SS => Strong Support" suggests, the spur gear support is increased, minimizing the chance of stripping gears.
By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.
A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)
Option part for IF18. This aluminum body mount spacer is to be used together with the optional 1 piece carbon mounting plate (R0198) Offers extra body post stability and is available in both silver and red.
As used by the team drivers at the 2019 World Championships. The chassis offers increased corner speed while also offering a smoother feel, this has been achieved by changing the shape of both the front and the rear of the chassis.
It is also possible to change the characteristics for different track conditions by adding a carbon plate (sold separately) to increase rigidity of the front section and adding an M3 screw to the rear.
Body stiffener for 1/8 body (Only large type for rear)
By extending the upper arm ball end boss by 3.5mm, the upper arm can be lengthened without any difficulty. The hole in the upper arm itself, which is combined with the upper arm, is also deeper, so it can be used in its shortest setting. Its now possiible to use this part for wide range of settings.
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.
The new SS version is more durable than previous gear housings due to a review of the manufacturing process, including the shape and materials used.
As the name "SS => Strong Support" suggests, the spur gear support is increased, minimizing the chance of stripping gears.
