![](http://www.creationmodel.net/catalog/3494-large_default/r0204-bearing-sp-5x8x25-2pcs.jpg)
![](http://www.creationmodel.net/catalog/3494-home_default/r0204-bearing-sp-5x8x25-2pcs.jpg)
Uses a softer material than the standard R0303-01.
Steering response is more mild and easy to drive.
Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.
Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.
A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.
Option part for Infinity IF18. This brake disc offers a more stable braking performance during long runs. The disc is made from thicker material than the standard item and also vented to efficiently dissipate heat. Improved brake feeling, spring included.
Changed contents of conventional R0117 (changed to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
Change of contents of conventional R0067 (to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.
This set of Φ8.5mm titanium ball screws is for use with the IF18-2. (Set includes 4 normal size and 2 long size) For smooth and light driving.
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
Spare part for R0337