R0331S05 - Fuel Tank Spacer 0.5cc (IF18-2)
The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.
16 other products in the same category:
R0283 - ALUMINIUM LONG BRAKE LEVER
High-precision machine cut of 7075 aluminum material. Compared with the standard brake lever in the kit it features two mounting positions of different lengths, allowing for stronger braking force and excellent control.
R0303-02S - FRONT SUSPENSION BUSH(IF18-2) SOFT
Uses a softer material than the standard R0303-01.
Steering response is more mild and easy to drive.
R0327 - ALUMINIUM OFFSET BUSHING (IF18-2)
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
R0341 - CARBON REAR STIFFENER SET(IF18-2)
Installing this part significantly improves rigidity to the rear section of the chassis around the gear area, enabling more reliable power transmission, increasing acceleration and top speed. In addition to this the increased pitching rigidity of the chassis helps to add initial response and a sharper steering feel.
R0224 - BODY STIFFNER FOR 1/8 RACING REAR (CARBON GRAPHITE)
Body stiffener for 1/8 body (Only large type for rear)
R0252T19 - 0.8M 1st PINION GEAR 19T
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
R0321 - ALUMINIUM FRONT LOWER ARM HOLDER SET each 4pcs (IF18-2)
This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.
The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.