R0303-01 - FRONT LOWER ARM END（IF18-2）

Uses harder material than standard IF18 kit. Increases the rigidity of the suspension and improves the corner speed.

DISCONTINUED

IF18 logo decal. Pre-cut decal is easy to attach. Size: 210mmx148mm

High-precision machined aluminum spring guide for improved steering response and rear traction. Hard coating is applied to ensure durability of the contact area with the spring and to maintain good condition for a long period of time.

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.

A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.

1.5mm shorter

High-precision machine cut of 7075 aluminum material. Compared with the standard brake lever in the kit it features two mounting positions of different lengths, allowing for stronger braking force and excellent control.

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Uses a softer material than the standard R0303-01. Increases crash resistance. The steering response is also mild.
(M2x8mm Flat Head Screw is not included.)

3.0mm shorter/Good matching for standard INFINITY(CM-00001)

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.