

This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.
This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
Making the material harder than the standard kit version the flex of the arm is reduced and rear traction is increased. Offering increased consistency in high grip and high temperature conditions.
Body stiffener for 1/8 body (Only small type)
High-precision machined aluminum spring guide for improved steering response and rear traction. Hard coating is applied to ensure durability of the contact area with the spring and to maintain good condition for a long period of time.
Body stiffener for 1/8 body (Only large type for rear)
A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.
The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.
This light weight lip spoiler set has a reduced weight of approx 5g including fastener and nut. Recommended for use with a lightweight bodyshell. Special carbon style features a printed INFINITY logo.
These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.
This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.