R0311 - FRONT CARBON WHEEL PLATE(IF18-2)

By installing this Front Carbon Wheel Plate on the front knuckle, turbulent air generated in the front wheels during driving is cleaned up offering more stable driving characteristics. The effect is especially noticeable on high-speed circuits.


16 other products in the same category:

CM-A005-30: ALUMINUM WASHER 3x6x3.0mm (Red/10pcs)

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

R0323 - FRONT LOWER ARM STIFFENER(CARBON) (IF18-2)

A carbon stiffener that can be added to the front lower arm to increase rigidity. Increased steering response and higher cornering speeds can be achieved in certain conditions. Its also possible to adjust the flex and rigidity by the number of mounting screws used.

R0314 - FRONT KNUCKLE BASE 13.5(IF18-2)

The front roll center can be lowered by replacing the kit parts with this front knuckle base. With these adjustments your IF18-II has the potential for even higher turning/steering performance. Recommended for use with thick front stabilizer from 2.6 - 3.0mm.

R0260 - ENGINE SCREW & WASHER SET

This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.

R0333 - FRONT ONEWAY SET 8mm (IF18-2)

An all new front one way set featuring larger one way bearings for improved durability. The timing of the drive transmission to the front tires has also been changed resulting in milder and more easy to drive characteristics. The overall weight has been reduced to 24g, 4g lighter than the original.