R0304-2.8 - FRONT ANTI-ROLL BAR 2.8mm(IF18-2)

DISCONTINUED

A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.

This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.

For rear only

Body stiffener for 1/8 body (Only large type for rear)

Spare part for R0333.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

3.0mm shorter/Good matching for standard INFINITY(CM-00001)

Spare part for R0337

These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.

Spare part for R0337