

A carbon stiffener that can be added to the front lower arm to increase rigidity. Increased steering response and higher cornering speeds can be achieved in certain conditions. Its also possible to adjust the flex and rigidity by the number of mounting screws used.
Front Shock Stay LD(Lay Down) that offers a position one step lower than the conventional R0081 (included in the kit). The center position of the R0336 is the same as the lower hole of the R0081. It's designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
Installing this part significantly improves rigidity to the rear section of the chassis around the gear area, enabling more reliable power transmission, increasing acceleration and top speed. In addition to this the increased pitching rigidity of the chassis helps to add initial response and a sharper steering feel.
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
By installing this Front Carbon Wheel Plate on the front knuckle, turbulent air generated in the front wheels during driving is cleaned up offering more stable driving characteristics. The effect is especially noticeable on high-speed circuits.
Uses lightweight carbon material. Chassis rigidity can be increased while suppressing weight increase. Improves steering response.
Uses a softer material than the standard R0303-01. Increases crash resistance. The steering response is also mild.
(M2x8mm Flat Head Screw is not included.)