R0304-2.5 - FRONT ANTI-ROLL BAR 2.5mm(IF18-2)

Now available as individual parts. R0303 is discontinued.

A carbon stiffener that can be added to the front lower arm to increase rigidity. Increased steering response and higher cornering speeds can be achieved in certain conditions. Its also possible to adjust the flex and rigidity by the number of mounting screws used.

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

Body stiffener for 1/8 body (Only small type)

Maintenance and adjustability is greatly improved with this servo saver arm by mounting to the steering rod upper side.  Also, by changing and optimizing the arm length of the servo saver, the steering response will be higher than before.

3.0mm shorter/Good matching for standard INFINITY(CM-00001)

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.

By extending the upper arm ball end boss by 3.5mm, the upper arm can be lengthened without any difficulty. The hole in the upper arm itself, which is combined with the upper arm, is also deeper, so it can be used in its shortest setting. Its now possiible to use this part for wide range of settings.

Uses harder material than standard IF18 kit. Increases the rigidity of the suspension and improves the corner speed.

Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.

A new aluminium servo horn designed specifically for IF18. 25T specification for servos made by Savox (SC2271SG) and Futaba (BLS371SV). By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).