R0302H - FRONT SUSPENSION HOLDER SET(IF18-2)

Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.

Spare part for R0337

A new aluminium servo horn designed specifically for IF18. 23T specification for servos made by Sanwa and KO. By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).

Upper arm holder machined from 7075 aluminuim material. The strength and rigidity are increased providing higher corner speed in certain conditions. The black anodized finish complete with Infinity logo also add a cool look to your car.

The material and coating have been updated to significantly improve crash resistance and durability compared to the standard items. The shaft is highly durable and resistant to scratches even after long periods of use.

Spare part for R0333.

Option part for Infinity IF18. This brake disc offers a more stable braking performance during long runs. The disc is made from thicker material than the standard item and also vented to efficiently dissipate heat. Improved brake feeling, spring included.

A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

Long life rubber belt

Changed to long upper arm