- CARS
- IF11 - 1/10 FORMULA
- IF11-2 1/10 FORMULA
- IF14 - 1/10 EP TC
- IF14-2 - 1/10 EP TC
- IF14-2 FWD - 1/10 EP TC
- IF14-2 FWD RS - 1/10 EP TC
- IF14-2 TEAM EDITION
- IF14-2 MID
- IF15 - 1/10 GP TC
- IF15W - 1/10 GP TC WIDE
- IF15-2 - 1/10 GP TC
- IF15-2W
- IF18 - 1/8 GP ONROAD
- IF18-2 - 1/8 GP ONROAD
- IF18-3 - 1/8 GP ONROAD
- IFB8 - 1/8 NITRO BUGGY
- IF11 - 1/10 FORMULA
- SPARE PARTS
- OPTION PARTS
- Accessories
- Infinity 1/8 onroad
16 other products in the same category:
R0270 - REAR LOWER ARM (HARD)
Making the material harder than the standard kit version the flex of the arm is reduced and rear traction is increased. Offering increased consistency in high grip and high temperature conditions.
R0200ST - BALL SCREW SET φ8.5mm (TITANIUM) 6pcs
This set of Φ8.5mm titanium ball screws is for use with the IF18-2. (Set includes 4 normal size and 2 long size) For smooth and light driving.
R0242 - REAR LOWER ARM PLATE LC (CARBON GRAPHITE) 2pcs
3.0mm shorter/Good matching for standard INFINITY(CM-00001)
R0331B - FUEL TANK SPACER FULL SET(IF18-2)
A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)
R0324 - TEAM SPEC BEARING(12x18x4) 2pcs
These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.
R0075-60R - FRONT UNIVERSAL SWING SHAFT 90°(L 60)2pcs
By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.
R0337 - REAR CARBON BODY MOUNT SET
Compared to the standard plastic rear body mount, this new carbon mount increases the height of the body by 3mm (Almost the limit within the regulation of IFMAR). In addition, the cross-sectional shape of the carbon plate and A7075 adapter matches the latest body shapes such as XTREAM's Diablo and Protoform's R19 without any gaps. This allows the downforce to be transferred to the tires without loss and improving rear grip. The left and right carbon plates can be fine-tuned with set screws to accommodate individual body shapes. The connection to the car body can be made in three step width directions, and also absorbs the twisting of the mounting part when toe-in is applied.
R0260 - ENGINE SCREW & WASHER SET
This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.