

By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.
A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)
Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.
Body stiffener for 1/8 body (Only small type)
Front Shock Stay LD(Lay Down)WIDE features a position 2mm wider each side than the R0336. Offers increased initial response than R0336. It is designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.