G125 - ADJUSTABLE FRONT ONEWAY SET

These innovative clutch weights sit between the flywheel pins and offer a higher clutch meet than a normal type weights making them suitable for use with basic engines such as 12TG from OS. Set screws are included to adjust the weight and clutch meet pressure. Also usable for high power engines.


16 other products in the same category:

G053H - HARD MAIN CHASSIS

This new hard type main chassis (G053) for IF15 was recently used to take the win at the 2018 World Championship in Miami. Featuring a stiffer rear section both traction and response is increased compared to that of the kit version.

G159 - REAR UPPER SUSPENSION PLATE (Slant/Carbon)

For IF15 / IF15W
Developed based on team driver feedback
A new carbon camber plate that can be adjusted in fine steps. The diagonal direction of the holes incorporates the latest setups for the IF15.
The bottom hole is the same original hole 2 (lower), the more you raise it, the more calm the rear will be.
(Part of the outer ball end needs to be cut)

G149 - SHOCK PISTON (φ1.1x2Holes/2pcs)

This is a spare part for short shock G147 for IF15/IF15W. 2 hole - 1.1mm piston. (3 hole - 0.9mm piston and 1 hole - 1.3mm is also available.

This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.

A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.

G160 - REAR A-ARM SET (Slant)

For IF15 / IF15W
Developed based on team driver feedback
Carbon camber plate (G159) that can be adjusted in a diagonal direction that incorporates the latest setups for the IF15.
In addition, the A-arm type camber link enhances rigidity and is a set of parts that greatly support rear grip.
The bottom hole is the same as original hole 2 (lower), the more you raise it, the more calm the rear will be.
(Part of the outer ball end needs to be cut)

G002B - FRONT BUMPER SET

The shape of the bumper tip has been changed to match the body shell used in the latest racing scene. The addition of ribs to increase the rigidity of the bumper has resulted in more efficient aerodynamics and improved maneuverability, especially at high speeds. The bumper plate has also been reshaped to improve crash resistance.

G050-OS - ENGINE MOUNT SET (for OS)

These engine mounts are specially designed for the O.S.12 engine. They are lowered and allow the engine crankcase to sit right at the chassis level contributing to a lower center of gravity.
The cooling fins on the sides allows the engine to better dissipate heat and help prevent overheating during a race.
(Do not use with non- O.S. engines as the crankcase and chassis may interfere with each other.)