G111 - REAR A-ARM SET

Replacement parts for R0026 FUEL TANK. 2pcs of P-18 Silicone O-Ring.

With this Front Shock Tower Ver. B, the shock position can be lowered, compared to the one with the shock tower included in the kit. A 2mm collar is included to prevent the shock from touching the bulk head.

Made of lightweight 7075 aluminum with hard coating.
Low gear ratio for short technical tracks.

G121-14 Chassis weight is 14g, half that of G0121 original optional chassis weight. Perfect for making finer setting adjustments. Can be used in all sliding weight positions and front bumper on IF15.

A high-quality 64 titanium ball screw set, when replacing the kit's standard φ8mm ball screws (front/steel, rear/aluminum), they reduce overall weight by approximately 3.3g and provides a light driving feel.

IF15/IF15Wに使用可能なショートショック専用のセッティングパーツ。
標準で付属の
2個穴-1.1mmピストンに対して
1個穴-1.3mmピストンはIF18-2のフロント用ピストンと同一サイズ、他に
3個穴-0.9mmピストンのタイプ(G124と同一サイズ)も発売。

ピストンの固定方法をIF14-2同様に極小のビスを採用し、ストロークを確保。
(専用の0.05インチサイズの工具が必要です。→[A0100] INFINITY 0.05" HEX WRENCH DRIVER　)

These engine mounts are specially designed for the O.S.12 engine. They are lowered and allow the engine crankcase to sit right at the chassis level contributing to a lower center of gravity.
The cooling fins on the sides allows the engine to better dissipate heat and help prevent overheating during a race.
(Do not use with non- O.S. engines as the crankcase and chassis may interfere with each other.)

For IF15 / IF15W
Developed based on team driver feedback
A new carbon camber plate that can be adjusted in fine steps. The diagonal direction of the holes incorporates the latest setups for the IF15.
The bottom hole is the same original hole 2 (lower), the more you raise it, the more calm the rear will be.
(Part of the outer ball end needs to be cut)

G124 New 3 hole shock pistosn for IF15. Recommended for the front end on IF15 on med-high traction tracks to increase corner speed. Can also be used in the rear and IF18 shocks.