G086-1.8 - FRONT STABILIZER BAR 1.8mm

This is a set of the servo saver parts, which are highly consumable parts included in the G012 servo parts set A. The set is available at a reasonable price.

These titanium ball screws contribute to improved grip by adding approximately 0.6 g of weight per ball screw compared to the kit's standard rear ballscrews (made of aluminum). In addition, the use of 64 titanium material with its increased rigidity improves response, especially on low to medium grip surfaces.

Special rubber with excellent durability is used to achieve longer life than the soft rubber type of the kit's standard parts. Especially effective for IF15W with high grip wide tires.

Used in combination with a specially developed short type shock.
The total shock length can be shortened by 4 mm.
The suspension stroke is maintained the same as the std shock type, and combined with the lower center of gravity, this offers sharper cornering and increased reaction.

These innovative clutch weights sit between the flywheel pins and offer a higher clutch meet than a normal type weights making them suitable for use with basic engines such as 12TG from OS. Set screws are included to adjust the weight and clutch meet pressure. Also usable for high power engines.

For IF15 / IF15W
Developed based on team driver feedback
Carbon camber plate (G159) that can be adjusted in a diagonal direction that incorporates the latest setups for the IF15.
In addition, the A-arm type camber link enhances rigidity and is a set of parts that greatly support rear grip.
The bottom hole is the same as original hole 2 (lower), the more you raise it, the more calm the rear will be.
(Part of the outer ball end needs to be cut)

Firmly fixing both ends of the upper suspension shaft with an E-ring and a stopper gives you added security from vibrations during long finals.

Spare parts for repairing short shocks that can be used for IF15/IF15W.

Overall length of 24mm.

Spare part for G164.

This is a spare part for short shock G147 for IF15/IF15W. 2 hole - 1.1mm piston. (3 hole - 0.9mm piston and 1 hole - 1.3mm is also available.

This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.

A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.

These engine mounts are specially designed for the O.S.12 engine. They are lowered and allow the engine crankcase to sit right at the chassis level contributing to a lower center of gravity.
The cooling fins on the sides allows the engine to better dissipate heat and help prevent overheating during a race.
(Do not use with non- O.S. engines as the crankcase and chassis may interfere with each other.)