G167 - REAR UNIVERSAL SHAFT (Parallel/52mm)

Replacement parts for R0026 FUEL TANK. 2pcs of P-18 Silicone O-Ring.

This is a spare part for short shock G147 for IF15/IF15W. 2 hole - 1.1mm piston. (3 hole - 0.9mm piston and 1 hole - 1.3mm is also available.

This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.

A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.

20g chassis weights are now available to adjust the front/rear balance of the IF15 and IF15W. The 20g weight can be used together with the 9.5g, 14g, and 28g weights already available on the market for more detailed tuning of your setup.

This new hard type main chassis (G053) for IF15 was recently used to take the win at the 2018 World Championship in Miami. Featuring a stiffer rear section both traction and response is increased compared to that of the kit version.

High-grade Japanese bearings are used to create an extremely smooth drivetrain. The INFINITY logo is also included to prove that it is team spec.

These titanium ball screws contribute to improved grip by adding approximately 0.6 g of weight per ball screw compared to the kit's standard rear ballscrews (made of aluminum). In addition, the use of 64 titanium material with its increased rigidity improves response, especially on low to medium grip surfaces.

These innovative clutch weights sit between the flywheel pins and offer a higher clutch meet than a normal type weights making them suitable for use with basic engines such as 12TG from OS. Set screws are included to adjust the weight and clutch meet pressure. Also usable for high power engines.

Features the same design shape as G154 rear shock tower (standard / carbon)
but designed to be used in combination with a specially developed short type shock.
The total shock length is shortened by 4 mm.
The suspension stroke is maintained the same as the std shock type, and combined with the lower center of gravity, this offers sharper cornering and increased reaction.
The body mount is 3.5 mm lower (one step of the body pin), which also contributes to lowering the center of gravity.

The shock mounting positions have been optimised to only the three inner positions, allowing for extra strength in this area in the event of a crash.

For IF15 / IF15W
Developed based on team driver feedback
A new carbon camber plate that can be adjusted in fine steps. The diagonal direction of the holes incorporates the latest setups for the IF15.
The bottom hole is the same original hole 2 (lower), the more you raise it, the more calm the rear will be.
(Part of the outer ball end needs to be cut)