G071-15 - 1st PINION GEAR 15T

This is a set of the servo saver parts, which are highly consumable parts included in the G012 servo parts set A. The set is available at a reasonable price.

Spare part for G166.

Special rubber with excellent durability is used to achieve longer life than the soft rubber type of the kit's standard parts. Especially effective for IF15W with high grip wide tires.

G121-14 Chassis weight is 14g, half that of G0121 original optional chassis weight. Perfect for making finer setting adjustments. Can be used in all sliding weight positions and front bumper on IF15.

These titanium ball screws contribute to improved grip by adding approximately 0.6 g of weight per ball screw compared to the kit's standard rear ballscrews (made of aluminum). In addition, the use of 64 titanium material with its increased rigidity improves response, especially on low to medium grip surfaces.

This new hard type main chassis (G053) for IF15 was recently used to take the win at the 2018 World Championship in Miami. Featuring a stiffer rear section both traction and response is increased compared to that of the kit version.

These innovative clutch weights sit between the flywheel pins and offer a higher clutch meet than a normal type weights making them suitable for use with basic engines such as 12TG from OS. Set screws are included to adjust the weight and clutch meet pressure. Also usable for high power engines.

For IF15 / IF15W
Developed based on team driver feedback
A new carbon camber plate that can be adjusted in fine steps. The diagonal direction of the holes incorporates the latest setups for the IF15.
The bottom hole is the same original hole 2 (lower), the more you raise it, the more calm the rear will be.
(Part of the outer ball end needs to be cut)

This is an option part for short shock for IF15/IF15W. 3 hole - 0.9mm piston. (3 hole - 0.9mm and 2 hole - 1.1mm piston is also available.

This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.

A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.