Repair parts for G268
These engine mounts are specially designed for the O.S.12 engine. They are lowered and allow the engine crankcase to sit right at the chassis level contributing to a lower center of gravity.
The cooling fins on the sides allows the engine to better dissipate heat and help prevent overheating during a race.
(Do not use with non- O.S. engines as the crankcase and chassis may interfere with each other.)
This titanium screw is for attaching the shock mounting to the IF14-II shock tower. It can be used to fine tune the steering feeling and grip between aluminium and steel.
Slim head screw machined from high quality 64 titanium material. For direct replacement of the steel rear body mount screws (R0120) of the IF18-2 and IF15W. Both lightweight and look cool.
These 64 titanium ball screws are approximately 1.5 g lighter per piece than the kit's standard parts for the front (made of steel). This material change slightly reduces rigidity for a smoother feel.
This is an option part for short shock for IF15/IF15W. 3 hole - 0.9mm piston. (3 hole - 0.9mm and 2 hole - 1.1mm piston is also available.
This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.
A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.
Sharper turning and more direct performance can be obtained on high-grip circuits.
A high-quality 64 titanium ball screw set, when replacing the kit's standard φ8mm ball screws (front/steel, rear/aluminum), they reduce overall weight by approximately 3.3g and provides a light driving feel.
A 20pcs pack of button head screws, as used in the Aluminum & Titanium Screw Set. High rigidity 7075 material is used allowing you to tighten the screws firmly. A great value pack.
These titanium ball screws contribute to improved grip by adding approximately 0.6 g of weight per ball screw compared to the kit's standard rear ballscrews (made of aluminum). In addition, the use of 64 titanium material with its increased rigidity improves response, especially on low to medium grip surfaces.
Firmly fixing both ends of the upper suspension shaft with an E-ring and a stopper gives you added security from vibrations during long finals.
Optimized shape to accommodate the updated thickness of (G187) front knuckle plate (hard) adopted on IF15-2. Additionally, reducing the clearance of the opening compared to the original product to efficiently control the airflow, which is the original purpose of the knuckle plate.
"Improved rigidity by using carbon-mixed nylon material. Improves steering response and enables increased racing line stability. It is particularly effective when used under high temperature conditions. *For identification, ""H"" mark is printed by laser engraving."
Repair parts for G268
