

By changing the position of the 2.0mm pin, stable rear grip can be obtained from low grip surfaces to high grip conditions.
For IF15 / IF15W
Developed based on team driver feedback
A new carbon camber plate that can be adjusted in fine steps. The diagonal direction of the holes incorporates the latest setups for the IF15.
The bottom hole is the same original hole 2 (lower), the more you raise it, the more calm the rear will be.
(Part of the outer ball end needs to be cut)
This tape is only 0.15mm thick and best suited for attaching a wing end plate and body parts.
This is a spare part for short shock G147 for IF15/IF15W. 2 hole - 1.1mm piston. (3 hole - 0.9mm piston and 1 hole - 1.3mm is also available.
This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.
A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.
The 2.0mm pin orientation has been changed to provide stable steering characteristics from low grip surfaces to high grip conditions.