G117 - AMB MOUNT (CARBON)

The combination of carbon and aluminum materials provides sharp steering characteristics with a highly rigid and lightweight finish. In addition, the included 4.9mm ball and aluminum spacer optimize bump steer and increase corner speed.

Improved rigidity by using carbon-mixed nylon material. Stabilizes the rear grip and allows for increased racing line stability. It is particularly effective when used under high temperature conditions. *For identification, the ""H"" mark is printed by laser engraving.

Please apply grease to the screw tightening areas when assembling in cold temperature environments.

Facilitates adjustment to reduce vehicle width when using wide offset tires.

20g chassis weights are now available to adjust the front/rear balance of the IF15 and IF15W. The 20g weight can be used together with the 9.5g, 14g, and 28g weights already available on the market for more detailed tuning of your setup.

Firmly fixing both ends of the upper suspension shaft with an E-ring and a stopper gives you added security from vibrations during long finals.

"Improved rigidity by using carbon-mixed nylon material. Stabilizes the rear grip and allows for increased racing line stability. It is particularly effective when used under high temperature conditions. *For identification, the ""H"" mark is printed by laser engraving. """

Special rubber with excellent durability is used to achieve longer life than the soft rubber type of the kit's standard parts. Especially effective for IF15W with high grip wide tires.

Mild and easy-to-control characteristics can be obtained when running on high-grip surfaces and large high-speed tracks.
G272 Hybrid Servo Saver Set is required.

Spare part for G272.

This is an option part for short shock for IF15/IF15W. 3 hole - 0.9mm piston. (3 hole - 0.9mm and 2 hole - 1.1mm piston is also available.

This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.

A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.

Mounted in the opening at the rear of the main chassis, it increases chassis rigidity at the rear end of the chassis and increases weight by approximately 13g to ensure stable rear grip. It is also effective when the track surface is high grip and traction roll occurs.
Use with G230 Carbon Rear Stiffener Set to expand the range of setting.

A high-quality 64 titanium ball screw set, when replacing the kit's standard φ8mm ball screws (front/steel, rear/aluminum), they reduce overall weight by approximately 3.3g and provides a light driving feel.

Spare parts for repairing short shocks that can be used for IF15/IF15W.

Dedicated one O-ring specification.
The overall length has been reduced to the utmost limit to achieve a low center of gravity.
Teflon coated surface for smooth operation.