G115 - FRONT BUMPER UPPER PLATE (CARBON)

Lowered shock tower for mounting short shock to IF15-2. As with the standard type, the damper mounting angle can be selected from 4 locations. Due to the lowered tower, the damper is 4mm shorter, offering a lower center of gravity. It is possible to enhance steering response and tune setup to your prefered driving feel. (Please use together with G147 short shock set)

R0262, R0263 Repair parts for accessories. 1mm short type "G084 BALL NUT 4.9 mm", they can be used for height adjustment of each pivot part of IF15.

This new aluminium center bulkhead ensures chassis rigidity in the center section of the car. Helps with traction and added stability in high grip situations.

Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)

Facilitates adjustment to reduce vehicle width when using wide offset tires.

G121-14 Chassis weight is 14g, half that of G0121 original optional chassis weight. Perfect for making finer setting adjustments. Can be used in all sliding weight positions and front bumper on IF15.

These titanium ball screws contribute to improved grip by adding approximately 0.6 g of weight per ball screw compared to the kit's standard rear ballscrews (made of aluminum). In addition, the use of 64 titanium material with its increased rigidity improves response, especially on low to medium grip surfaces.

Special rubber with excellent durability is used to achieve longer life than the soft rubber type of the kit's standard parts. Especially effective for IF15W with high grip wide tires.

Improved rigidity by using carbon-mixed nylon material. Stabilizes the rear grip and allows for increased racing line stability. It is particularly effective when used under high temperature conditions. *For identification, the ""H"" mark is printed by laser engraving.

Please apply grease to the screw tightening areas when assembling in cold temperature environments.

IF15/IF15Wに使用可能なショートショック専用のセッティングパーツ。
標準で付属の
2個穴-1.1mmピストンに対して
1個穴-1.3mmピストンはIF18-2のフロント用ピストンと同一サイズ、他に
3個穴-0.9mmピストンのタイプ(G124と同一サイズ)も発売。

ピストンの固定方法をIF14-2同様に極小のビスを採用し、ストロークを確保。
(専用の0.05インチサイズの工具が必要です。→[A0100] INFINITY 0.05" HEX WRENCH DRIVER　)

This is an option part for short shock for IF15/IF15W. 3 hole - 0.9mm piston. (3 hole - 0.9mm and 2 hole - 1.1mm piston is also available.

This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.

A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.

By replacing the original kit plastic part with this high-precision 7075 machined part, all flex and deflection will be eliminated, resulting in excellent consistency and sharp steering characteristics.