G267 - FLYWHEEL (TG Clutch/30mm)

Spare part for G260

Features the same design shape as G154 rear shock tower (standard / carbon)
but designed to be used in combination with a specially developed short type shock.
The total shock length is shortened by 4 mm.
The suspension stroke is maintained the same as the std shock type, and combined with the lower center of gravity, this offers sharper cornering and increased reaction.
The body mount is 3.5 mm lower (one step of the body pin), which also contributes to lowering the center of gravity.

The shock mounting positions have been optimised to only the three inner positions, allowing for extra strength in this area in the event of a crash.

Prevents the side belt from falling off when a heavy load is applied to it.

Mounted in the opening at the rear of the main chassis, it increases chassis rigidity at the rear end of the chassis and increases weight by approximately 13g to ensure stable rear grip. It is also effective when the track surface is high grip and traction roll occurs.
Use with G230 Carbon Rear Stiffener Set to expand the range of setting.

These 64 titanium ball screws are approximately 1.5 g lighter per piece than the kit's standard parts for the front (made of steel). This material change slightly reduces rigidity for a smoother feel.

"Improved rigidity by using carbon-mixed nylon material. Improves steering response and enables increased racing line stability. It is particularly effective when used under high temperature conditions. *For identification, ""H"" mark is printed by laser engraving."

Improved rigidity by using carbon-mixed nylon material. Stabilizes the rear grip and allows for increased racing line stability. It is particularly effective when used under high temperature conditions. *For identification, the ""H"" mark is printed by laser engraving.

Please apply grease to the screw tightening areas when assembling in cold temperature environments.

Facilitates adjustment to reduce vehicle width when using wide offset tires.

This is an option part for short shock for IF15/IF15W. 3 hole - 0.9mm piston. (3 hole - 0.9mm and 2 hole - 1.1mm piston is also available.

This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.

A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.

R0262, R0263 Repair parts for accessories. 1mm short type "G084 BALL NUT 4.9 mm", they can be used for height adjustment of each pivot part of IF15.

Spare part for G260

Spare part for G272.

"Improved rigidity by using carbon-mixed nylon material. Stabilizes the rear grip and allows for increased racing line stability. It is particularly effective when used under high temperature conditions. *For identification, the ""H"" mark is printed by laser engraving. """