G265 - CLUTCH DISK (TG Clutch)

The combination of carbon and aluminum materials provides sharp steering characteristics with a highly rigid and lightweight finish. In addition, the included 4.9mm ball and aluminum spacer optimize bump steer and increase corner speed.

This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (4.3 grams compared to the steel version's 8.3 grams) allows you to save weight and achieve maximum performance. It can also be installed on the rear hub. Using the M170 on the rear end of your vehicle provides additional support, which is recommended for high-grip and fast tracks.

This part is crafted from 7075-T6 alloy, significantly enhancing the stiffness of the central diff mounting. Additionally, it improves heat dissipation and facilitates a smoother transmission, resulting in enhanced performance.

The 7.0T front shock spring provides a marginally softer suspension than the stock spring (6.67T), strategically enhancing front-end grip. This adjustment is particularly advantageous on dusty and loamy track surfaces, where increased traction is essential for optimal performance.

These 7075-T6 spacers serve as replacements for the plastic ones included in the kit. Offering a longer lifespan compared to their plastic counterparts, they effectively maintain smooth servo saver movement even under the load exerted by the steering links.

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

Made of superior quality 1.6mm thickness of U.S.A. carbon material.
Compare with kit normal thickness 2.0mm, further chassis flex is gained and initial steering response can be increased.
Provides great efficiency use with optional Aluminum Flex Main Chassis(T109).

The drivetrain of the IF18-3 has been lightened to improve response during acceleration and deceleration.
The weight is approximately 7g lighter than the 8mm shaft.

Mounted in the opening at the rear of the main chassis, it increases chassis rigidity at the rear end of the chassis and increases weight by approximately 13g to ensure stable rear grip. It is also effective when the track surface is high grip and traction roll occurs.
Use with G230 Carbon Rear Stiffener Set to expand the range of setting.

Steering knuckle plate for IF15-2 and IF15-2W, which allows for a greater steering angle of the outer tire in corners than the standard kit version.
This will make tighter cornering possible, and can improve high speed steering on larger tracks.

IFB8 shock stroke and rebound gauge. Allows easy measurement of important shock length while mounted on the vehicle during suspension setup. Supports stroke from 60mm to 150mm. Can also be used on vehicles other than IFB8.