G261 - CLUTCH BELL GUIDE (TG Clutch/L7.8)

Spare parts for repairing short shocks that can be used for IF15/IF15W.

Overall length of 24mm.

This is an option part for short shock for IF15/IF15W. 3 hole - 0.9mm piston. (3 hole - 0.9mm and 2 hole - 1.1mm piston is also available.

This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.

A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.

Spare part for G260

This is an upgraded version of IF15front one-way set. By replacing the bevel gear with the newly-designed one-way plate, The one way dampening effect can be better controlled. In addition, this set enables the operation to be more stable for a longer period of time. Silicone oil of a part number between 100000 and 500000 and rubber glue or silicon sealing agent are required for assembly.

Spare part for G260

Brake pads that can be used with IF15-2/2W and IF18-3.
Compared to the standard soft (red), this pad enhances initial braking, allowing you to tune your preferred feeling when entering the corner.
By mixing this pad with the standard (soft (red)), you can create an intermediate feeling.
(There is an identification marking on one side, apply adhesive to this side only)

Mild and easy-to-control characteristics can be obtained when running on high-grip surfaces and large high-speed tracks.
G272 Hybrid Servo Saver Set is required.

Spare part for G272.

Improved rigidity by using carbon-mixed nylon material. Improves steering response and enables increased racing line stability. It is particularly effective when used under high temperature conditions. *For identification, ""H"" mark is printed by laser engraving.

The combination of carbon and aluminum materials provides sharp steering characteristics with a highly rigid and lightweight finish. In addition, the included 4.9mm ball and aluminum spacer optimize bump steer and increase corner speed.

Pinion gear with improved durability compared to the standard part, achieved by reviewing the material and coating.

Spare part for G260

These titanium ball screws contribute to improved grip by adding approximately 0.6 g of weight per ball screw compared to the kit's standard rear ballscrews (made of aluminum). In addition, the use of 64 titanium material with its increased rigidity improves response, especially on low to medium grip surfaces.